Single Step, Single Stage
Inline Pretreatment Washers
Our single stage inline conveyor wash systems combine the cleaning performance of our high pressure hot water system with articulating nozzle arrays for full part coverage for inline conveyor production operations while reducing wash booth length by over 60% of traditional stage washers
-
High Pressure, Hot Water Wash System With Articulating Nozzle Arrays
-
Precision Coverage With Designed Nozzle Placement
-
On The Fly Controllable Wash System Flow And Pressure Settings For Part Variation
-
Zero Discharge, Closed Loop Filtration Process
-
Reduce Wash Booth Footprint By Over 60% Compared To Traditional Stage Washer
-
New System Implementation Or Existing System Conversion
Clean
Pretreat
Recycle
High Pressure, Spray Wand Metal Cleaning
If unmatched quality and zero rejects are your expectations for your finished large parts, CPR SYSTEMS™ delivers. A high-pressure hot water bath containing a single step cleaner, degreaser phosphate or zirconium pretreatment chemistry. This is a no to low rinse operation leaving behind a clean substrate with conversion coating for increased paint adhesion and corrosion resistance.
Spray Wand Phosphate Or Zirconium Pretreatment
This process not only cleans better than most other methods, but leaves behind a conversion coating that significantly improves paint adhesion, deters flash rusting and corrosion, increases salt spray times, and significantly reduces your rejected parts rates. The finish quality on the products you deliver to your customers will be among the best. That translates to higher customer satisfaction and increased sales.
Increase Paint Adhesion / Corrosion Resistance
High Pressure, High Heat Washing Systems Combined With Cleaner Coater For Superior Cleaning Performance
Reduce Water And Chemical Consumption
Greater Than 80% Water And Chemistry Reduction Compared To Wash And Discharge Operations
Complete Environmental Compliance
Zero Discharge, Nothing Goes To Drain. Closed Loop Recycling Packages For Filtration To Under 20 Micron For Reuse.
Single Step Efficiency
We Combine The Cleaning And Coating Into A Single Step To Maximize Pretreatment Efficiency
High Performance
Spray Wand For Batch Operations
-
Designed up-front for future expansion
-
Variable cleaning pressures up to 3,000 PSI at 180 degrees
-
Cleaning power of a 5-stage washer in your hand
-
Improve paint adhesion on metal substrates
-
Speed up pre-treatment time and labor
-
Improve corrosion resistance
-
Built for years of dependable service
What Our Clients Say
“We switched from just pressure washing using a degreaser to a CPR phosphate cleaning system with recycling. We greatly reduced our chemical consumption and eliminated discharging any wash waters. We continue to see the savings to this day. We have been using CPR SYSTEMS for over 10 years.”
Greg Snyder
President, Car Mate Trailers
“Our goal was to improve our finishing department. The CPR SYSTEM did this for us by eliminating solvent wiping and speeding up the overall operation. We now clean and phosphate our products for improved coating performance. The recycling system has eliminated the environmental issues when using a phosphate pretreatment product.”
Jim Liggett
President, Ropes Courses Inc
“We were sand blasting our large parts and solvent wiping the others...
This not only reduced our blasting cost but eliminated the use of hazardous chemicals for cleaning sheet metal parts. We have done this with zero discharge into the sewer system.”
Roger Kroes
Operations Manager, Sharp Iron Group
Metal Finishing Equipment For Over 35 Years
Proudly providing metal finishing solutions to clients all across North America.
